How to enable combined dmcl and dfc trace?

梦里梦外; 2022-01-10 03:43 264阅读 0赞

[http://vsrr2020.blogspot.com/2008/02/how-to-enable-combined-dmcl-and-dfc.html][http_vsrr2020.blogspot.com_2008_02_how-to-enable-combined-dmcl-and-dfc.html]

1. Make sure that you have added the following lines to dfc.properties file found in the documentum/config directory.  
  
\#  
  
\# Specifies whether to enable or disable trace.  
  
\#  
  
dfc.tracing.enabled = on  
  
\#  
  
\# Specifies whether to record the parameter information of methods, if any,  
  
\# while tracing.  
  
\#  
  
dfc.tracing.recordParameters = on  
  
\#  
  
\# Specifies whether to record the return value of methods, if any, while tracing.  
  
\#  
  
dfc.tracing.recordReturnValue = on  
  
\#  
  
\# Specifies whether to record timing information while tracing.  
  
\#  
  
dfc.tracing.recordTiming = off  
  
\#  
  
\# Specifies whether to record thread information while tracing.  
  
\#  
  
dfc.tracing.recordThreading = on  
  
\#  
  
\# Specifies whether to output multiple trace outputs on to a single line or not.  
  
\#  
  
dfc.tracing.compactMode = on  
  
\#  
  
\# Specifies how many levels deep the method calls need to be traced.  
  
\# Valid values: 0 and above.  
  
\#  
  
dfc.tracing.stackDepth = 100  
  
\#  
  
\# Specifies whether to combine the trace of dmcl along with other traces.  
  
\#  
  
dfc.tracing.combineDMCL = on  
  
2. Save the dfc properties file.  
  
3. The DFC logs will be created within the documentum/logs directory. These will be fairly large!  
  
4. Once you have collected the required log, disable the tracing again by setting dfc.tracing.enabled = false  
  
and afterwards save the properties file.

转载于:https://www.cnblogs.com/xioxu/archive/2008/09/30/1302475.html

[http_vsrr2020.blogspot.com_2008_02_how-to-enable-combined-dmcl-and-dfc.html]: http://vsrr2020.blogspot.com/2008/02/how-to-enable-combined-dmcl-and-dfc.html