Windows/Mac安装zookeeper

左手的ㄟ右手 2022-06-14 06:06 217阅读 0赞

**1. 下载页面:** http://www.apache.org/dyn/closer.cgi/zookeeper/

**2. 解压下载的压缩包**:  zookeeper-3.4.10.tar (或zookeeper-3.4.10.tar.gz), 放置在期望的目录, 譬如: C:\\Coding\\zookeeper-3.4.10

**3. 修改配置**

进入conf目录, 将zoo\_sample.cfg复制一份, 起名为: zoo.cfg

如下内容供参考:

# The number of milliseconds of each tick
    tickTime=2000
    
    # The number of ticks that the initial 
    # synchronization phase can take
    initLimit=10
    
    # The number of ticks that can pass between 
    # sending a request and getting an acknowledgement
    syncLimit=5
    
    # the directory where the snapshot is stored.
    # do not use /tmp for storage, /tmp here is just 
    # example sakes.
    dataDir=D:\\data\\zookeeper
    dataLogDir=D:\\logs\\zookeeper
    
    # the port at which the clients will connect
    clientPort=2181
    
    # the maximum number of client connections.
    # increase this if you need to handle more clients
    # maxClientCnxns=60
    #
    # Be sure to read the maintenance section of the 
    # administrator guide before turning on autopurge.
    #
    # http://zookeeper.apache.org/doc/current/zookeeperAdmin.html#sc_maintenance
    #
    # The number of snapshots to retain in dataDir
    # autopurge.snapRetainCount=3
    # Purge task interval in hours
    # Set to "0" to disable auto purge feature
    # autopurge.purgeInterval=1

**4. 启动**

使用cd命令到bin目录下, 执行以下命令启动

.\zkServer.cmd

**Mac系统下：**

如果系统已安装brew，这步忽略：

$ /usr/bin/ruby -e "$(curl -fsSL https://raw.githubusercontent.com/Homebrew/install/master/install)"

使用brew安装zookeeper:

$ brew install zookeeper

在 /usr/local/etc/zookeeper/ 路径下配置zoo.cfg，内容和windows类似

安装路径: /usr/local/Cellar/zookeeper/3.4.10

启动

$ zkServer 
    JMX enabled by default
    Using config: /usr/local/etc/zookeeper/zoo.cfg
    Usage: ./zkServer.sh {start|start-foreground|stop|restart|status|upgrade|print-cmd}
    
    $ zkServer  status
    JMX enabled by default
    Using config: /usr/local/etc/zookeeper/zoo.cfg
    Error contacting service. It is probably not running.
    
    $ zkServer  start
    JMX enabled by default
    Using config: /usr/local/etc/zookeeper/zoo.cfg
    Starting zookeeper ... STARTED
    
    $ zkServer status
    ZooKeeper JMX enabled by default
    Using config: /usr/local/etc/zookeeper/zoo.cfg
    Mode: standalone

参考： http://blog.csdn.net/whereismatrix/article/details/50420099

enjoy it !